A. Precautions before installation: 1. The machine should be cleaned before using the installation shaft. And check the installation shaft if there is a touch, dirt, if all should be cleared clean.
2. The use temperature of the reducer is 0~40℃.
3. Check the mating dimensions of the holes (or shafts) that are connected with the reducer to meet the requirements, and the tolerances of the holes shall be H7 (the tolerance of the shaft is H6).
4. The top of the plug should be used before the exhaust screw plug to ensure that the deceleration of the body gas discharge.
Next: No Information
- The Use And Maintenance Of The Redu...
- Performance Characteristics Of Gear...
- Selection Of Gear Reducer
- Cause Analysis Of Oil Leakage In Re...
- Gear Reducer
- Installation And Use Of Reducer
- The Origin Of The Development Of Gear
- Development Situation Of Gear Indus...
- Gear Development
- Gear Classification